|
Categories
01) Undersink Water Filters
02) Benchtop Water Filters
03) Reverse Osmosis Water Filter
04) Reverse Osmosis Custom Built
4A) Desalinator for Boats
06) Whole House Water Filters
07) Water Filter Cartridges
08) Water Filter Package Deals
09) Fluoride Removal Water Filte
11) Bore Water Filter Solutios
11A) Iron Reduction Water Filter
12) Water Filter / Parts & Acces
14) Recycled Water Solutions
14a) Water Cooler Rentals
15) Pottery Water Filters
17) Minraliser/Anti-Oxidant/Alka
19) Caravan Water Filters
21) Camping & leisure Water Filt
22) Coffee Machine In-line Filte
23) Ionizers/Alcaline Water
|
|
|
| *Flickmixer Installation for a water filter |
|
|
 |
1) TURN OFF COLD STOP COCK WHERE THE FLICKMIXER
HOSE JOINS.
2) RELEASE PRESSURE BY TURNING THE FLICKMIXER ON
3) UNSCREW HOSE OR PIPE FROM COLD STOP COCK
4) JOIN STOP COCK TO TEE PIECE WITH HALF INCH SOCKET USING PLUMBERS TAPE AND THEN THE HOSE OR PIPE FROM THE FLICKMIXER TAP TO THE OTHER SIDE
5) CONNECT SUPPLIED STOP COCK TO THE TEE PIECE USING PLUMBERS TAPE AND THEN THE PLASTIC HALF INCH X QUARTER INCH FITTING TO THE SUPPLIED STOP COCK
6) CONNECT THE 2 PLASTIC QUARTER INCH X QUARTER INCH FITTINGS TO THE HOUSINGS USING PLUMBERS TAPE IF THEY ARE NOT ALREADY BUILT INTO THE SYSTEM
7) DRILL HOLE IN SINK IN DESIRED POSITION USING FIRST A PILOT HOLE( THE SMALLEST DRILL BIT YOU HAVE) TO MAKE IT EASIER FOLLOWED BY A 12 MM HOLE THEN FIT THE FAUCET FINALLY SCREWING THE PLASTIC FITTING FOR THE FAUCET IN PLACE.
8) RUN A PIECE OF HOSE FROM THE PLASTIC HALF INCH X QUARTER INCH FITTING ON THE SUPPLIED STOPCOCK TO THE PLASTIC QUARTER INCH FITTING AT THE INLET OF THE WATER FILTER WHICH WILL BE THE ONE WHERE THE PRE FILTER OR STAGE ONE IS.
9) CONNECT ANOTHER PIECE OF HOSE FROM THE PLASTIC QUARTER INCH FITTING ON THE OUTLET SIDE OR STAGE 2 (OR 3 IF YOU HAVE THE TRIPLE SYSTEM) TO THE PLASTIC FITTING ON THE FAUCET.
10) TURN BOTH OF YOUR STOP COCKS BACK ON AND RUN YOUR WATER FILTER FOR 6-8 MINUTES ALLOWING THE CARBON TO SOAK AND THE OXYGEN TO PASS THROUGH THE SYSTEM, THEN YOU CAN DRINK AND COOK WITH OUR WATER FILTER WORLD PURE WATER SYSTEM.
STANDARD INSTALLATION
1) TURN WATER OFF, RELEASE PRESSURE THROUGH TAP, CUT APROX 2-3CM OUT OF THE COPPER PIPE DEPENDING ON HOW FLEXIBLE THE PIPE IS.
2) SCREW THE 2 NUTS OFF AT BOTH SIDES OF THE TEE AND PUSH THEM OVER BOTH SIDES OF THE COPPER PIPE, FOLLOWED BY THE OLIVES.
3) TIGHTEN NUTS DOWN ONTO THE TEE THEN FOLLOW THE REST OF THE FLICKMIXER TAP INSTRUCTIONS FROM STEP 5.
|
|
|
| Shopping Cart |
  |
|
| 0 items |
|
|
|
|
|
| How-to Information |
|
|
| Bestsellers |
|
|
| What's New? |
|
|
| Quick Find |
|
|
| Information |
|
|
|
